Quick question. Replacing the temp gauge sender on the GT. Use teflon tape on the threads, or does it seal well enough by itself?
Quick question. Replacing the temp gauge sender on the GT. Use teflon tape on the threads, or does it seal well enough by itself?
---
Jim
2010 Mercedes E550
2000 Mazda Miata Special Edition
Sold: 2001 10th Anniversary Cobra #353
1990 Mustang GT Convertible
2002 Mustang GT
Think they may have orig used a redish pipe dope but teflon tape will work, what I'd do. just couple wraps.
Thanks George.
---
Jim
2010 Mercedes E550
2000 Mazda Miata Special Edition
Sold: 2001 10th Anniversary Cobra #353
1990 Mustang GT Convertible
2002 Mustang GT
Jim, they use Permatex high temperature thread sealer. I have some I just bought a few weeks ago. You're welcome to use it, or you can get it at any Autozone, etc.
Bruce
TFS TW heads, rockers, 75mm intake, cam, 75mm TB, CAI, MAF, DeatschWerks 35# injectors, Aeromotive rails/regulator, 255 pump, BeCool rad, alum water pump, MSD 6A/coil, alum flywheel, PP, driveshaft, McLeod clutch, Torsen T2R, 3.73, 31spline axles, 17" 95 Cobra R, NT-05 255/275, MM CC plates, coil-over (Bilstein), rlca, K-brace, A-arms, SF conns, Cobra brakes, =len shorties, 2.5" SS Hpipe, Borla CB...