-
Senior Member
New Dyno Numbers
Made a little trip up to see Pete yesterday and run my Shelby on the dyno after my winter mods. Ran some pretty good numbers. 717 hp to the rear wheels, 740 ft lbs torque, which should put me at 825hp or so at the motor. Now if it could just warm up so I can keep it on the ground. 80 feet of rubber in second gear can get pretty hairy!
Dyno Numbers 4-16-2020 (2).jpg
-
Moderator
Bruce
TFS TW heads, rockers, 75mm intake, cam, 75mm TB, CAI, MAF, DeatschWerks 35# injectors, Aeromotive rails/regulator, 255 pump, BeCool rad, alum water pump, MSD 6A/coil, alum flywheel, PP, driveshaft, McLeod clutch, Torsen T2R, 3.73, 31spline axles, 17" 95 Cobra R, NT-05 255/275, MM CC plates, coil-over (Bilstein), rlca, K-brace, A-arms, SF conns, Cobra brakes, =len shorties, 2.5" SS Hpipe, Borla CB...
-
Senior Member
SVT COBRA
-
Senior Member
I spoke with Ryan last week at a store he was stocking up. He said he too is getting some major engine work done. Be nice to get cars out this year.
Mine coming out of my trailer today.
-
Senior Member
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules