Torque specs on 2012 Front Shock nuts

[PonikNH]

I installed the "Steeda" strut brace on my 2012 V6 Yesterday afternoon. I have been checking that the nuts are still tight. I had no settings in the directions so I choose 30 ft-lbs of torque. I have found that I can turn them 1/4 of turn before the torque wrench clicks. So I stop being so "thorough" and leave them alone because they are fine. Or do I need to torque them to a higher number?
Thanks
PonikNH

[Jibber]

I'm surprised they weren't listed in the instructions. When in doubt call the manufacturer. They should be able to provide the info to you.

Torque specs are important.

[PonikNH]

Did a little diggin' on the net today and found this post http://www.allfordmustangs.com/forums/2011-v6-mustang-tech/349215-painted-strut-brace.html So I over tightened by about 4 ft-lbs. Thanks for the replies. See you all next Saturday.